A site plan revision including two construction phases has been approved.

The Taylor Zoning Board of Adjustment approved a variance requesting relief from the requirement to install a waterline on the west side of 1102 East 4th street.

A site plan for commercial development in Taylor, TX has been officially approved.

Bryan Technical Services has been contracted to do surveying and platting.

Neagu Civil Engineering has been contracted to make a site-plan for two 4000 sq. ft. buildings.

An old storage-building has been removed from our land.

Our land in Taylor, TX is paid off and ready for improvements.

A prototype of our original pot-rack has been fabricated. After some sandblasting, it'll be good to go.

Our Passport Plus is back with a new CO2-solenoid. Welds have been much smoother with CO2 flowing freely.

It looks like our Passport Plus is down. The CO2-solenoid never seemed to open fully. After some tests, it ended up stuck partially open.

A Millermatic Passport Plus (portable MIG welder) has been received and is performing well with CO2.

Equipment necessary for cutting and welding with oxyacetylene has been acquired and tested.

The formation-paperwork for Beveridge Brothers Welding Co., LLC has been submitted to the Secretary of State (Texas).